MSS specialise in the installation of fully developed Multipoint Autogas systems for a vast range of petrol vehicles and offer a FREE no obligation quotation service

Before 1998 Single Point System...

On earlier vehicles that have the early petrol injection systems we can fit a single point LPG autogas system. This is less expensive than the Sequential Injection System that is required for the later petrol injection vehicles. The tank arangment is the same for all conversions.
The basic components are as follows:
Gas Tank: Usually mounted in the boot or under the boot floor in place of the spare wheel
Filler Point: This is located either on the vehicle panel or rear bumper skirt.
Regulator: This unit is mounted in the engine bay and allows the liquid gas coming from the tank under its own pressure to be vaporized by the means of water heating taken from the vehicles engine.
Single Point Mixer: Fitted to the inlet manifold where the LPG Autogas is introduced into the engine.
Change over switch: This unit can be mounted discreetly on the vehicle dashboard. The switch has a small push button that allows the driver to select the fuel to run on either petrol or LPG.  The switch also incorporates a fuel gauge.
Change over switch
Filler Point
mickleton service station
Lightning Signs teesdale signage company